MBF Motorcycle Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
134 Posts
Seen it done here is the pic up close.
I am gona take mine and get it done if some place could do it.

 

·
Registered
Joined
·
134 Posts
no i met him during bike week at the yamaha booth. He said that it sounds like a V-8
you could probley go to a weld shop and have them cut it out
 

·
Registered
Joined
·
100 Posts
i would like to do mine at work this week like this because i have all the tools here to do it but of course I'll have to do it after 330 and before the office leaves so i was wondering to remove the back half has anybody done this and if so what is the procedure for it what heatshields need to be removed these welds that need to be cut can i get to them without removing the whole exhaust and when I'm done do they have to be tack welded again when you put them on?

i just need to know so i know what kind of time I'm looking for to do this because i will be limited before they close up i don't want to be stuck halfway into the mod so any pics or desciption on heatshields etc.. is appreciated
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top